1. Overview

This procedure guides how to capture system configuration screens for troubleshooting and verification purposes.

📌 Important Notes:

• DO NOT modify any values in these screens.
• Any issues caused by unauthorized changes will not be covered under warranty.
• After capturing the required screenshots, send them to the AS Team (hanlaas@hanlaims.com).

2. Procedure for Capturing Screens

Step 1: Access the ARRANGE Screen

1. On the touchscreen, press "MODE SELECT".
2. Select "ENGINEER", then "ARRANGE".
   

Step 2: Enter the Password

1. In the PASSWORD input screen, enter one of the following:
   • "0607"
   • "333"
   • "0916"
     
     
2. Press "ENT" to proceed.

Step 3: Capture Required Screens

1. After logging in, capture a screenshot of the first screen (ARRANGE screen).
   
   
2. Navigate to "PARAMETER" or "PARAMETER SETTING 1", then capture a screenshot.
   
3. Navigate to "NO.1 AL SET" or "ALARM SETTING 1", then capture a screenshot.
   
4. Navigate to "NO.2 AL SET" or "ALARM SETTING 2", then capture a screenshot.
   

Step 4: Log Out and Verify Level 2 Access

1. On the top right corner of the touchscreen, press "LOG OUT".
   
2. Press "LOG IN" again.
   
3. Enter "222" as the password and press "ENT".
   
4. Verify that "LEVEL 2" is displayed on the top right corner of the screen.
   

3. Sending Screenshots

• Once all screenshots are captured, send them to the AS Team (hanlaas@hanlaims.com).

4. Summary of Key Actions