1. Introduction
This procedure provides instructions for resetting the Combi Module by temporarily removing power. This method can help resolve communication errors and operational faults in the module.
2. Steps for Resetting the Combi Module
-
Loosen the Module:
- Using a flat-head screwdriver ("-"), gently detach the Combi Module from its slot.
- Ensure the module is completely powered off (all indicator lamps should turn off).
-
Wait for Power Drain:
- Keep the module disconnected for at least 10 seconds to allow residual power to dissipate.
-
Reinstall the Module:
- Carefully slide the module back into its original position.
- Ensure a secure connection before releasing the module.
-
Verify System Operation:
- Observe the indicator lamps – they should turn back on after reinstallation.
- Check system functionality via the control panel or monitoring system.
3. Troubleshooting Guide
| Issue | Possible Cause | Recommended Action |
|---|---|---|
| Module does not power on | Loose connection | Reseat the module and ensure proper contact |
| System still unresponsive | Faulty module or power issue | Check the power source and module health |
| Error indicators remain | Software or wiring fault | Check wiring connections and consult system logs |
4. Additional Notes
- Only perform this procedure if a reset is required due to system faults.
- Do not forcefully remove the module to avoid hardware damage.
- Ensure proper seating of connections before restarting the system.
Comments
0 comments
Please sign in to leave a comment.