1. Introduction

This manual provides step-by-step instructions for checking and verifying the cable connections of the flow meter. Proper cable handling and secure connections are essential for accurate flow meter performance.

2. Cable Disassembly Procedure

1. Disconnect the Cable:

   • Carefully separate the external cover from the cable.
   • Ensure that you disconnect cables in the correct sequence (1 to 4).

2. Inspect the Cable Connection:

   • Check the cable connection status for any signs of damage, wear, or looseness.
   • Use a screwdriver to ensure the cables are securely fixed and do not come loose.

⚠️ Caution: Handle cables with care to avoid damaging connectors or internal wiring.

3. Cable Assembly and Verification

1. Reassemble the Connector:

   • Pay close attention to the PORT alignment when reassembling the connector to prevent incorrect connections.

2. Power Supply Verification:

   • After assembly, verify that the flow meter powers on correctly.
   • Check the display or indicator lights to confirm proper operation.

4. Terminal Pin Configuration

Ensure each wire is connected to the appropriate pin for accurate flow meter performance.

5. Troubleshooting Tips

• Flow Meter Does Not Power On:

  • Verify all cable connections are secure.
  • Check for proper alignment of the connector with the port.
  • Ensure power supply voltage is within the required range.

• Unstable Readings:

  • Inspect the cable for any loose connections.
  • Confirm there are no signs of cable damage or interference.