Introduction
This manual provides detailed instructions for using the Winclon system to recover or restore your PC. Two primary methods are described:

1. Using the F11 Key
2. Using a Booting USB

Section 1: Recovery Using F11 Key

1. Power on your PC.
2. Press F11 during boot to enter the RECOVERY ZONE.
3. Once in the RECOVERY ZONE, click the Recovery button in the center of the screen.
4. Confirm recovery by clicking YES in the dialog box.
5. After the recovery is complete, exit the Winclon interface using the X button in the upper right corner.

Section 2: Recovery Using Booting USB

1. Connect the BOOTING USB to your PC and turn it on.
2. Enter BIOS MODE by pressing DELETE during boot.
3. In BIOS MODE, go to the BOOT TAP section and change Boot Option #1 to the connected Generic Flash Disk (Booting USB).
4. Navigate to SAVE & EXIT TAP and click SAVE CHANGES AND RESET.
5. After the reset, the system will automatically enter the RECOVERY ZONE.
6. Follow the on-screen instructions to click the Shortcut and enter the WIZARD.
7. In the WIZARD:
   • Click the upper right corner.
   • Select BOOTMEDIA → WINCLONBACKUP → WCL FILE and click OK.
   • Select the image file and click NEXT.
8. Change the operation to Restore Entire Disk and click NEXT.
9. Select the items indicated and click Restore to proceed with recovery.
10. Once recovery is complete, exit the Winclon interface using the X button in the upper right corner.